X-Spat Controller 2.0 provides two complementary screens to visualize a set-up: the main window, which always remains visible, with parameters that can be modified in real time, and the Patchbay window for internal connections to the card. In the main window you can manage, independently for each selected audio/MIDI channel, the X-Spat parameters that are modifiable in real time.
Select the switch button marked with the same number as the channel for which you want to set input and output parameters. Modify the parameters as you wish. Repeat the operation for all channels and save your setup file in the hard disk. At any time, you can select the button Send to send the necessary MIDI Control Change messages to X-Spat.
Features:
•Input Level: regulates the input volume of the Spatializer for the selected channel.
•Input LPF (Low Pass Filter) Cutoff: sets the cut off frequency of the first-degree Low Pass filter for the selected channel.
•Gain Enhance: increases or decreases the level of the spatialized signal for the selected channel within the area designated by the speakers.
•Input HPF (High Pass Filter) Cutoff: sets the first-degree high pass filter cutoff frequency for the selected channel.
•Bell Factor: it allows you to compensate for the speaker's directionality for the output of the selected channel.
•Attenuation: Regulates the percentage of level variation for the selected channel in relation to the distance of the source from the center of the virtual cube.
•Doppler Depth: sets the depth of the Doppler effect for the selected channel.
•Source Position Manager: set the position in the virtual space of the audio source.
•ITD (Interaural Timing Difference) Depth: sets the depth of the ITD intervention for the selected channel.
•Front-Rear Spectral Enhance: sets the depth of intervention of the filter dedicated to the simulation of the rear positioning of the source in relation to the center of the virtual cube for the selected channel .
•Speaker X (Y or Z) Position
New features:
•ReWire support, now all the midi control change messages can be send via ReWire mid channel.
•ReWire transport.
New lock interface.